How To Fix Ink Jams On The Printer

Hello. This time I will share How To Fix Ink Jams On The Printer. Here's how

1. Make sure the cartridge contains ink according to its capacity (maybe less, as long as not more).

2. Perform Deep Cleaning several times through the Printer Properties tool.

3. Do a Test Print to see the results.

4. Perform steps 2-3 above several times.

5. If still jammed, clean the cartridge head with a special liquid sold at computer stores.

If there isn't, you can clean it with alcohol. After cleaning, tap the cartridge on the palm of your hand. If there is ink dripping, it means the ink can come out.

Repeat steps 2-3 above.

6. If still jammed, try pumping the cartridge through the ink filling hole slowly until the ink looks out of the cartridge head. Then do the steps 2-3 above again.

7. If it is still jammed, then there are 2 (two) most extreme final steps, namely soaking the Cartridge Head in hot water, and dismantling the cartridge. However, these two steps are not recommended, unless you are desperate, and ready for the risks, "buy a new cartridge".

To soak, provide enough hot water in a wide container. Dip the surface (only the surface, not more) of the cartridge head into the water for about 2-3 seconds. Dry the cartridge head, and do the steps 2-3 above again.

To disassemble the cartridge head, poke the cartridge cover with a knife. Remove the ink absorbent foam, then clean the outlet of the ink with a special liquid that has been prepared.

If the ink looks like jelly on the absorbent foam, remove the foam by soaking it in rubbing alcohol. Do not wring it out so that the shape is not damaged.

Just drain it. After dry, put it back and close the cartridge as before tightly.

Fill the cartridge with ink, then perform steps 2-3 above again.

Good Luck!